Taper only available one side

Home Forums Support Forums TURBOSPLINES Taper only available one side

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #5437
    Hemajith samarakoon
    Participant

    Hi,
    In my project i need to make Spline both side tapered, is their anyway i can achieve this? Hope to hear from you soon. Thank you.
    VFX Squad

    #5439
    rode3d
    Keymaster

    Hi Hemajith,

    Yes, you can make a symmetrical taper effect by using ‘Invert Taper’ + Tip Lenght. Do the following:

    1. Build or re-build the TS geometry with all the Extra Features on (Taper, Tip, Slice).
    2. Go to TS Edition section
    3. Check ‘Invert taper’ on.
    4. At ‘Tip Parameters’ group, go increasing the ‘Tip Length’ value while you see the result in the TS mesh until the wider part of the mesh is located at the middle of the path/mesh.
    That’s all.

    Best Regards,

    Hernán Rodenstein
    SplineDynamics.com

    #5441
    Hemajith samarakoon
    Participant

    Hi Hernán, Wow really Thank you for the super fast feed back, you save my day..its really working and I just wonder how come that I’m not aware of this until you said..hikz….hope to buy another 3 of your products soon. wish you all the very best and keep safe from corona…cheeers
    Hemajith
    VFX Squad

    #5442
    rode3d
    Keymaster

    Great, Hemajith!
    Glad to help 🙂
    Keep safe you too!
    Cheers!
    Hernan R.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.